Đ8:00.0 Ethernet controller: Intel Corporation 82574L Gigabit Network Connection Đ4:00.0 RAID bus controller: Broadcom / LSI MegaRAID SAS 2008 (rev 03) Đ2:04.0 PCI bridge: Microsemi / PMC / IDT HIO524G2 PCI Express Gen2 Switch (rev 02) Đ2:03.0 PCI bridge: Microsemi / PMC / IDT HIO524G2 PCI Express Gen2 Switch (rev 02) Đ2:02.0 PCI bridge: Microsemi / PMC / IDT HIO524G2 PCI Express Gen2 Switch (rev 02) Đ1:00.0 PCI bridge: Microsemi / PMC / IDT HIO524G2 PCI Express Gen2 Switch (rev 02)
#Lsi megaraid storage manager reset password series
Đ0:1f.3 SMBus: Intel Corporation 5 Series/3400 Series Chipset SMBus Controller (rev 05)
Đ0:1f.2 SATA controller: Intel Corporation 5 Series/3400 Series Chipset 6 port SATA AHCI Controller (rev 05) Đ0:1f.0 ISA bridge: Intel Corporation 3420 Chipset LPC Interface Controller (rev 05) Đ0:1e.0 PCI bridge: Intel Corporation 82801 PCI Bridge (rev a5) Here is the extract from "system devices" page But I managed to find a spare 2.5" 60gig drive lying around so I connected it to the raid controller and loaded up Unraid. The reason I didn't load Unraid to try yet was I am yet to purchase the drives I'm going to put on the server. I and others from what I have seen here don't load the card's BIOS as we aren't using the RAID function.Īs I understand it, it doesn't matter if the card is IT or IR as the latter's RAID is turned off to let unRAID apply the RAID mode. If it doesn't, you really need to access the BIOS. Anyway, the firmware version should be part of the text that goes by during computer bootup sequence. I don't know how important it is to have the latest firmware. To unpack reply a bit, HBA is Host Bus Adapter. So, as I understand it, you do not want even JBOD mode. These cards are being used to add SATA ports to a motherboard. Ummm, be ready and press ctrl+g sooner to enter the card's BIOS settings? Will Unraid work with this controller in JBOD mode?ī) How do I tell if the controller is already flashed or in IT model prior to flashing? There is EFI command line i can boot into. When I press ctrl + g it doesnt go into raid bios. Have a couple of questions for those that are experienced.Ī) At the moment on system boot I get a message saying the raid controller is in JBOD mode. I have been doing research prior to installing Unraid on this system and noted discussions around firmware crossflashing for IT mode. Recently I picked up a Intel Server Board S3420GP system with an Intel RAID Controller RS2WC080.
0 kommentar(er)
